Adding a fully integrated 4th- or 5th-axis Haas brushless rotary table to your Haas VMC creates a supercharged machining center package that boosts your productivity and reduces setups. Fully synchronized 4th- and 5th-axis configurations are available on most Haas VMC models.
Utilizing a Haas HRT310 and a pillow-block support, this dynamic setup can position the part to almost any angle. When compared to multiple manual setups, this is highly efficient.
An HRT210 employing a Haas QuickCube system that allows machining of multiple parts on each side of the cube, and fast changeovers from cube to cube, increasing spindle run time.
Machine up to five sides of a part, eliminate multiple operations and setups, and increase your production output by using a 2-axis tilting rotary table.
This high-productivity application utilizing a custom, multi-part fixture and Haas tailstock increased output by more than 500%.
VMC
OPTIONS & ACCESSORIES
The chart to the right illustrates the relationship between flow and pressure. For both the 300-psi and 1,000-psi through-spindle coolant options, the highest pressure occurs at the lowest flow rate. The actual pressure delivered to the cutting edge depends on the size of the coolant passages in the tool. Smaller coolant passages restrict the flow, causing the pressure to increase (up to the maximum provided by the system). Conversely, larger coolant passages in the tool allow more fluid to pass through, resulting in lower pressure at the cutting edge.
