Servo-Driven SMTC - Двойная рука Сетка Offset и инструмент Changer Offset

Last updated: 04/04/2021

(Servo-Driven SMTC) - Двойная сетка arm Offset и смещение смены инструментов - NGC

Double Arm Grid Offset and Tool Change Offset - Introduction

In software version 100.17.000.1037 and later the TT axis is now the TA axis. Refer to the Next Generation Control - Axis Assignments procedure.

Tools Required:

Haas Control Key

NGC - Servo-Driven SMTC - Double Arm Grid Offset and Tool Changer Offset

1

Power on the machine with your Haas Control Key.

Change Setting 53 to On.

Change Setting 9 to Inch.

Press [DIAGNOSTIC].

Navigate to the I/O tab [2] in the Diagnostics tab [1].

Type SMTC [3] and press [F1].

Navigate to the Factory tab [5] in the Parameters tab [4].

Type TT/TA [6] and press [F1].

Note: Software version 100.17.000.1037 and later the TT is now the TA axis but the parameter numbers are the same.

2

Press [EMERGENCY STOP].

Navigate to Parameter 11.019 [1].

Type 0.

Press [ENTER].

Navigate to Parameter 11.078.

Type 0.

Press [ENTER].

Release [EMERGENCY STOP].

Make the TT/TA Axis visible in the Position box [2]. Refer to Next Generation Control - Position View - Axis Selection.

3

Press [T/TA]. Press [HANDLE JOG]. Press [.001/1.]

Press [DIAGNOSTIC].

Navigate to the I/O tab in the Diagnostics tab.

[HANDLE JOG] the T/TA Axis in the clockwise direction until the Value for Input Number 72 and 91 are 1.

4

Press [T/TA]. Press [ZERO RETURN]. Press [SINGLE].

Press [EMERGENCY STOP].

Press [DIAGNOSTIC].

Navigate to the Factory tab in the Parameters tab.

Navigate to Parameter 11.140.

Press [T/TA]. Press [F4].

Release [EMERGENCY STOP].

5

Press [T/TA]. Press [HANDLE JOG]. Press [.001/1.].

Press [DIAGNOSTIC].

Navigate to the I/O tab in the Diagnostics tab.

[HANDLE JOG] the T/TA Axis in the clockwise direction until the Value for Input Number 72 and 91 are 1.

Press [T/TA]. Press [ZERO RETURN]. Press [SINGLE].

Press [T/TA]. Press [HANDLE JOG]. Press [.001/1.].

Press [DIAGNOSTIC].

[HANDLE JOG] the T Axis in the clockwise direction until the Value for Input Number 72 and 91 are 1.

Continue to handle jog the T Axis clockwise (2) revolutions. The Value for Input Number 72 and 91 must remain at 1.

6

Navigate to the Factory tab in the Parameters tab.

Press [EMERGENCY STOP].

Navigate to Parameter 11.078.

Type the negative value of the T/TA-Axis Position. For example, if the value for the T/TA-Axis Position is 8.9911, type -8.9911.

Press [ENTER].

7

Navigate to Parameter 11.019.

Type 1.

Press [ENTER].

Release [EMERGENCY STOP].

Change Setting 53 to Off.

Свяжитесь с нами

Servo-Driven SMTC - Double Arm Grid Offset and Tool Changer Offset - NGC

(Servo-Driven SMTC) - Двойная сетка arm Offset и смещение смены инструментов - NGC