After you install and initialize the software and use the Parameter Checker Program, do these procedures:
Important: When this procedure is completed, make sure that the correct optional functions are enabled. ENTER THE BILL TIME CODE IF AVAILABLE. If the Bill Time code is not available, be sure to increase the time to the maximum date permitted from the Haas portal.
Note: When all of these procedures are completed, cycle the power (1) time.
Note: To operate correctly, a replacement Maincon must have a Mocon firmware version that is the same as, or higher than, the version of the initial Maincon. The replacement Maincon must also have the the same, or higher, Communications Firmware (“Floppy”) version. If necessary, do the Mocon Firmware Upgrade and the Communications Firmware ("Floppy Version") Replacement for a Maincon Processor.
Note: You must create new backup files.