Install the muffler-tube assembly  onto the housing for the live tooling. Put the other end of the muffler-tube assembly into the lathe adjacent to the power and encoder cables .
Fully clean the mating surface  on the housing.
Apply white lithium grease to (1) side of the MOTOR GASKET [C].
Put the side of the gasket that has grease against the mating surface  on the housing.
Install the MOTOR ASSEMBLY [G] into the housing.
Install the (4) screws  to install the motor. Tighten the screws in a star pattern. Torque the screws to 25 ft lb (34 Nm).
Connect the power and encoder cables . Use the CABLE TIES [F] to attach the cables to the muffler-hose assembly.
Install the cover for the motor.
Do a test of the live tooling for the correct operation.