NGC software version 100.19.000.1303 has been released and is available for download from the Haas Portal.
- Erroneous 4018 alarm generated when using G112. The Y-axis motions on G112 were not being reset after leaving G112 mode if there is no Y-axis on the lathe. Now the control will update lathe's without Y-axis similar to the lathe's with a Y-axis. This issue has been fixed in this version (TP# 41073)
- The turret does not index to the correct tool during APL pickup. This issue has been fixed in this version (TP# 41085).
- In software versions after 100.19.000.1100, after synchronizing the spindle with G199, if you command a C0 it un-wraps thousands of degrees. This issue has been fixed in this version (TP#41186)
For a complete list of corrections refer to the release notes on the Haas Portal >Service Tab> Documents and Software > Control Software > Next Generation Control > Mill, Lathe and Simulator Software.