Domov servisu Postupy Konverzia vretena UMC-400 10K
Last updated: 06/13/2025

Motor vretena UMC-400 10K - konverzia konfigurácie WYE

AD0868

Revision A - 06/2025

Introduction

This procedure details the re-wiring of the UMC-400 junction box (JBOX) to improve low-speed torque. This procedure only applies to UMC-400s with the 10K spindle option and a 20HP Vector Drive.

20HP vector drives have a decal on the front that reads 'Vector Drive HFD-2'.

This document applies to the following service kits:

  • 93-5084 UMC-400 10K SP WYE CONFIG CONVERSION KIT

Remove Sheet Metal

1

Jog the spindle downward until the entire spindle head cover [1] is visible and within reach. Power off the machine.

 

Remove the spindle head cover.

2

Remove bolts securing the JBOX cover [1].

Update Wiring

1

Aktualizovať zapojenie

2

Chcete vytiahnuť nové parametre z HBC?

WYE Configuration Activation

Turn on the machine. 

Service Techs Only: Log in to the HBC PORTAL. Download the WYE conversion patch files. Load the option configuration patch file to the control. Refer to the Next Generation Control - Configuration File - Download/Load procedure.

Note: The option files will appear on the configuration download page after it has been ordered. If the option does not appear, contact the service department.