11.1 Tornio da tavolo - Guida alla risoluzione dei problemi

Introduction

The Haas Desktop Lathe is the ultimate training machine for schools and technical colleges.

Powered by a full-function Haas CNC control housed in our portable simulator enclosure, the Desktop Mill is perfect for teaching the basic principles of programming and operating a CNC mill.

Designed to cut plastics and machinable wax, it is also perfect for hobbyists and benchtop machinists.

Symptom Table

Symptom Possible Cause Corrective Action
No axis load while the machine is in motion. None There is no force feedback to the control from the axis motors or amplifiers. Therefore, no axis load will show on the control. The machine is operating normally as intended. 

Estop and Alarm 107

Symptom: The Estop button is released, but alarm 107 EMERGENCY STOP does not reset. 

Possible Cause: The primary Estop cable [1] is disconnected from its port J9 [2] labeled "Estop SIM" on the table top adaptor. 

Corrective Action: 

If no parts are damaged, plug the cable back in and cycle power the machine. 

If the cable [1] is damaged, replace the cable and power cycle the machine. P/N 33-0673

If the port [2] is damaged, replace the table top adaptor.  P/N 93-32-3097

11.2 Desktop Lathe - Wiring Diagrams

Note: The part numbers are for reference only and may not be available to be ordered. 

Electrical Cabinet Wiring Diagram

Control Cabinet Wiring Diagram