연락처

Power on the machine with your Haas Control Key.

• For instructions on how to create a Haas Control Key refer to NGC - Haas Control Key

Set the grid offsets, refer to NGC - Axis Grid Offset.

Push [ZERO RETURN].

Push [ALL].

Place a tool holder into the double-arm.

Mount a 0.0005" indicator [2] and mag-base to the machine table.

Place the indicator tip on the bottom [1] of the toolholder [3].

Set the indicator to 0.

Jog the table away from the toolholder.

Do not move the indicator.

Move the toolholder from the double-arm to the spindle.

Jog the table to position the indicator under the toolholder.

Do not hit the spindle with the indicator.

Jog the Z Axis up or down until the indicator goes back to zero.

Push [DIAGNOSTIC].

Navigate to the Factory tab in the Parameters tab.

Type 3.078 and push [F1].

Push [F2] Set Z Axis Tool Changer Offset.

The Z Axis Tool Changer Offset Done prompt appears.

Set the spindle orientation offset, refer to NGC- Side-Mount Tool Changer - Spindle Orientation Offset.

Do several tool changes to test the tool changer operation.

 After you do this procedure, inform the customer they need to reset their tool length offsets.