Push [5% RAPID], [ZERO RETURN], [Z], then [HOME] G28.
The Z Axis moves to the tool change height.
If the tool change height is correct, the indicator goes back to zero.
If the indicator does not go back to zero, repeat this procedure
Caution: You must always remove your Haas Control Key and power off the machine when you finish work on the machine.
Be sure to set the spindle orientation offset.
Refer to Next Generation Control - Umbrella Tool Changer - Spindle Orientation Offset.
Do several tool changes to test the tool changer operation.
Note: When you are finished, inform the customer they will need to reset the tool length offsets.