IMX6 Carrier Board - Replacement

Last updated: 05/29/2026

IMX6 载板 - 更换

AD0943

版本 A - 2026 年 5 月

Introduction

此过程将向您展示如何更换 Haas 机床内的 IMX6 载板。

此板用于：

15" 监视器模拟器
桌面铣床
台式车床
SR 机床

IMX6 载板也是上述机床内部 A62 板的替代品。

此程序适用于以下服务套件：

93-5704: SVC IMX6 CARRIER ASSY

注意： IMX6 载板所需的最低软件版本为 100.24.000.1600。

Replacing IMX6 Carrier Board

注意： 对 CNC 机器及其部件进行维护或维修时，必须始终遵循基本安全预防措施。这降低了人身伤害和机械损坏的风险。

将主断路器设置为 [OFF] 位。

危险： 在控制柜内开始任何工作之前，高压指示灯将亮起 320V Power Supply / Vector Drive 必须关闭至少 5 分钟。

某些服务程序可能很危险或危及生命。不要尝试您不完全理解的过程。如果您对执行一项程序有任何疑问，请联系您的 Haas 专卖店 (HFO) 并安排服务访问。

1

Remove the back panel [1] of the pendant by unscrewing the eight bolts [2].

2

Disconnect all the cables going to the IMX6 carrier board [1].

Remove the old IMX6 carrier board [1] from inside of the pendant by unscrewing the four bolts [2] in the corners of the carrier board

3

Replace the original IMX6 carrier with the new IMX6 carrier board from the replacement kit [1]. Reuse the same screws as before [2] to mount it to the enclosure subplate.

4

Connect cable 33-8298B (CBL 22.5" DISP DATA LCD TO SBC-A62J PCB) [1] to the 15" LCD screen Display Data Port and to J20 on the IMX6 carrier board.

Connect cable 79-0194 (CABLE RJ45 SHIELDED TWISTED PAIR 2FT) [2] to J28 on the SKBIF and the other end to J3 on the IMX6 carrier board.

Connect cable 33-1496 (CBL DSKTP PCB +12V PWR 2.0FT) [3] to P3 on the PCM board and J15 on the IMX6 carrier board.

Connect cable 33-1474 (CBL PWR IMX8 CARRIER) [4] to J2 on the PCM board and J19 on the IMX6 carrier board.

Connect cable 33-1475 (CBL PCM PWR DWN TO IMX8 CRR) [5] to P2 on the PCM board and J11 on the IMX6 carrier board.

The USB extention cable, 79-2000, connects to the right USB port, J5, on the IMX6 carrier board.

The ethernet port cable, 79-0091, connects to the top ethernet port, J9, on the IMX6 carrier board.